Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1629 (Lighting System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement (Two-mode Hybrid) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition to the OFF position and remove the ignition key.
  2. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
    3. Fig 1: Brake Pedal Position Sensor & Bolts
    GM2246978Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the brake pedal position sensor electrical connector.
  4. Remove the brake pedal position sensor bolts (1).
    5. Fig 2: Brake Pedal Position Sensor
    GM2246979Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake pedal position sensor (1).
scientia non olet · About Mike's Workshop Manuals