Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1475 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lock Housing Bolts
    GM928840Courtesy of GENERAL MOTORS CORP.
  1. Pre-assemble the lock housing and multifunction lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 in) gap at the bolt ends.
    2. IMPORTANT: Ensure that the lock tab fully engages into the column slot.
  2. Slide the bracket onto the column.
  3. Hand-tighten the lower bolt until snug.
  4. Hand-tighten the upper bolt until snug.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Tighten the lower bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in)

  6. Tighten the upper bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in)

    7. Fig 2: View Of Ignition Housing Electrical Connectors
    GM928832Courtesy of GENERAL MOTORS CORP.
  7. Connect the ignition housing electrical connectors.
    8. Fig 3: View Of Multifunction Lever
    GM928835Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that both locking tabs are seated.
  8. Install the multifunction levers.
  9. Install the upper and lower shrouds. Refer to Steering Column Trim Covers Replacement .
  10. Install the SIR coil. Refer to SIR COIL ASSEMBLY in Air Bag Restraint Systems.
  11. Install the steering wheel. Refer to Steering Wheel Replacement .
  12. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
scientia non olet · About Mike's Workshop Manuals