Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1402 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Front Camber Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the strut to the vehicle. Refer to STRUT, STRUT COMPONENT AND/OR SPRING REPLACEMENT in Front Suspension.

    Tighten 

    Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle.

  2. Install the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Adjust the camber (1).

    Tighten 

    Tighten the strut-to-knuckle bolts to 122 N.m (90 lb ft).

    Fig 1: Identifying Front Camber
    G01569396Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals