Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1254 (Body Rear End) >> Repair Instructions >> Handle Replacement - End Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Aztek and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the endgate handle to the endgate handle assembly.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts to the endgate handle.

    Tighten 

    Tighten the endgate handle bolts to 10 N.m (89 lb in).

  3. Close the endgate.
    Fig 1: View Of Endgate Handle Assembly
    G01722851Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals