Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1248 (Electronic Suspension System - Automatic Level Control) >> Repair Instructions >> Automatic Level Control Air Dryer and Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the automatic level control air compressor from the vehicle. Refer to Air Compressor Replacement .
  2. Clean the area around the connection of the automatic level control air dryer to the automatic level control air compressor body.
  3. Disconnect the electrical connector from the pressure sensor.
  4. Remove the air dryer/pressure sensor assembly retaining screw.
  5. Push the air dryer/pressure sensor assembly in while rotating the air dryer/pressure sensor assembly clockwise until the assembly detaches from the automatic level control air compressor body.
  6. Remove the automatic level control air dryer from the automatic level control air compressor.
scientia non olet · About Mike's Workshop Manuals