Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls - Removal & Installation, Overhaul) >> Ignition Systems >> Ignition Control Module >> Removal & Installation (3.1L & 3.4L)

Removal & Installation (3.1L & 3.4L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect ignition control module harness connectors. See Figure . Disconnect spark plug wires from the ignition coil(s). Note the position from which the wires are removed. Remove screws securing the ignition coils to the ignition control module.
  2. Remove the ignition coils. Remove the ignition control module from the bracket. To install, reverse removal procedure. Tighten ignition coil screws to specification. See TORQUE SPECIFICATIONS  . Reconnect spark plug wires. See Figure .
scientia non olet · About Mike's Workshop Manuals