Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1146 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering pressure hose (2) to the vehicle.
    Fig 1: Installing Power Steering Pressure Hose
    G01419077Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the power steering pressure hose (2) to the power steering gear.

    Tighten 

    Tighten the fitting to 27 N.m (20 lb ft)

  3. Install the power steering pressure hose (2) to the power steering pump (1).

    Tighten 

    Tighten the fitting to 27 N.m (20 lb ft)

  4. Lower the vehicle.
  5. Bleed the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM  .
scientia non olet · About Mike's Workshop Manuals