Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1083 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Wiper Motor Cover Screws
    GM512036Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor cover to the wiper motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wiper motor cover screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  3. Install the wiper system drive module. Refer to Wiper Motor Module Replacement .
scientia non olet · About Mike's Workshop Manuals