Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1066 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAP Sensor
    GM54360Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the screws that attach the manifold absolute pressure (MAP) sensor to the bracket.
  3. Disconnect the MAP sensor electrical connector.
  4. Disconnect the MAP inlet vacuum hose.
  5. Remove the MAP sensor from the bracket.
scientia non olet · About Mike's Workshop Manuals