Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1015 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Pitman Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pitman arm to the power steering gear.
    Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut
    GM398127Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install a new pitman arm washer and nut.

    Tighten:  Tighten the nut to 250 N.m (184 lb ft).

  3. Remove the power steering gear from the vise.
  4. Install the power steering gear. Refer to Power Steering Gear Replacement (Rack and Pinion) or Power Steering Gear Replacement (Non Rack and Pinion) in Power Steering System.
  5. Lower the vehicle.
  6. Check the wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
scientia non olet · About Mike's Workshop Manuals