DTC 21/31: Courtesy Lights Feed Circuit Shorted To Ground: Testing
NOTE:
Incorrect installation of aftermarket electronic equipment may effect system operation.
- Turn ignition switch to OFF position. Remove and check COURTESY fuse No. 8 (20-amp) from instrument panel fuse block. If fuse is open, go to next step. If fuse is okay, go to step 3 .
- Check for short to ground in Orange wire between BCM and instrument panel fuse block. Repair wire as necessary. If wire is okay, replace COURTESY fuse.
- Disconnect BCM connector C2. Connect a test light between BCM connector C2 terminal "B" (Orange wire) and ground. See Figure . If test light comes on, go to step 5 . If test light does not come on, go to next step.
- Repair open in Orange wire between BCM and instrument panel fuse block and/or open in Red wire between instrument panel and fusible link "E".
- Ensure glove box is closed. Using DVOM, check continuity between BCM connector C2 terminal "E" (Dark Blue/White wire) and ground. If resistance is zero ohms, go to next step. If resistance is more than zero ohms, go to step 7 .
- Repair short to ground in Dark Blue/White wire between BCM and appropriate interior light.
- Replace BCM. See BODY CONTROL MODULE (BCM) under REMOVAL & INSTALLATION.