VTSS Test 3A - VTSS Indicator Lamp Illuminates While Driving
NOTE:
Perform VTSS TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) harness connectors. PCM is located between left inner fender and power distribution center. Inspect connector terminals No. 59 and 60. Repair as needed and go to next step.
- Reconnect PCM harness connectors. Using scan tool, read PCM status. While observing scan tool, wiggle harness. If scan tool displays NO RESPONSE FROM PCM, inspect specified circuits between Body Control Module (BCM) and PCM for open. See CCD BUS CIRCUIT IDENTIFICATION table. If scan tool does not display NO RESPONSE FROM PCM, problem may be intermittent.
CCD BUS CIRCUIT IDENTIFICATION
| BCM Terminal No. | Wire Color | PCM Terminal No. |
|---|---|---|
| 3 | Violet/Brown | 59 |
| 34 | White/Black | 60 |