Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Plymouth >> 1997 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Vehicle Communications Tests >> Test 10B - Bus Short To Battery

Test 10B - Bus Short To Battery

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-2A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Turn ignition off. Using scan tool in ohmmeter mode, measure resistance between Powertrain Control Module (PCM) connector terminals No. 44 (Orange wire) and No. 59 (Violet/Brown wire). PCM is located on left inner fenderwell, near battery. If resistance is less than 5 ohms, repair short between Orange wire and Violet/Brown wire. If resistance is 5 ohms or more, go to next step.
  2. Measure resistance between PCM connector terminals No. 44 (Orange wire) and No. 60 (White/Black wire). If resistance is less than 5 ohms, repair short between Orange wire and White/Black wire. If resistance is 5 ohms or more, replace PCM.
scientia non olet · About Mike's Workshop Manuals