Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Plymouth >> 1997 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Computer Tests >> Chime Test 7A - Chime Inoperative With Driver's Door Open & Key In Ignition

Chime Test 7A - Chime Inoperative With Driver's Door Open & Key In Ignition

NOTE: Perform CHIME TEST 1A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-1A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Turn ignition off. Open driver's door. If chime does not sound, go to next step. If chime sounds, system is currently functioning correctly.
  2. Using scan tool, read driver's door ajar switch status. If scan tool displays DRDOOR AJAR SWITCH: CLOSED, go to next step. If scan tool does not display DRDOOR AJAR SWITCH: CLOSED, go to DOOR AJAR TEST 3A  .
  3. Using scan tool, read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: CLOSED, go to next step. If scan tool displays KEY-IN IGNITION SW: CLOSED, replace Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure in CHIME TEST 2A.
  4. Disconnect key-in ignition switch connector. See Figure in CHIME TEST 4B. Connect jumper wire between connector terminals. Using scan tool, read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: CLOSED, go to next step. If scan tool displays KEY-IN IGNITION SW: CLOSED, replace ignition switch. See STEERING COLUMN SWITCHES article in the ACCESSORIES/SAFETY EQUIPMENT section.
  5. Connect jumper wire between ground and Light Blue wire on key-in ignition switch connector. Using scan tool, read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: CLOSED, go to next step. If scan tool displays KEY-IN IGNITION SW: CLOSED, repair open ground (Black wire) circuit.
  6. Access Body Control Module (BCM) connector "A". BCM is located with junction block under driver's side instrument panel. See Figure in CHIME TEST 2A. Remove connector cover. Do not disconnect connector. Connect jumper wire between terminal No. 4 (Light Blue wire) and chassis ground. Go to next step.
  7. Using scan tool, read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: CLOSED, replace BCM. If scan tool displays KEY-IN IGNITION SW: CLOSED, repair open Light Blue wire between BCM and ignition switch.
scientia non olet · About Mike's Workshop Manuals