Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1775 (Sunroof System & Luggage Carrier) >> Repair Instructions >> Roof Moveable Panel Control Module Calibration Procedure

Roof Moveable Panel Control Module Calibration Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Power roof relearn will be necessary anytime the power roof module (PRM) or power roof motor has been replaced. The power roof will be relearned when the PRM learns the full open and full close positions.

To relearn the power roof:

  1. Follow instructions on the scan tool under Special Functions, Roof Auto Relearn.
  2. If the PRM terminates the relearn procedure and displays the message SEE SERVICE MANUAL, proceed to the following steps.
  3. Exit the Roof Auto Relearn procedure.
  4. Select Open/Close Roof.
  5. Using the Open/Close Roof command, fully open the roof.
  6. Using the Open/Close Roof command, fully close the roof making sure that the roof latches.
  7. Exit the Open/Close Roof procedure.
  8. Rerun the Roof Auto Relearn procedure.
scientia non olet · About Mike's Workshop Manuals