Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pipe To Brake Master Cylinder Removed

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake pipe to the brake master cylinder.
Tighten: Tighten the brake pipe fitting 25 N.m (18 lb in).

Fig 2: Rear Brake Pipe Removed

Courtesy of GENERAL MOTORS CORP.

Install the rear brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb in).

Fig 3: Right Front Brake Pipe Removed

Courtesy of GENERAL MOTORS CORP.

Install the right front brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb in).

Fig 4: Electronic Brake Control Module (EBCM) View

Courtesy of GENERAL MOTORS CORP.

Install the left front brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb in).
Install the EBCM to the vehicle. Refer to Brake Pressure Modulator Valve (BPMV) Replacement .
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Bleed the brake system. Refer to ABS Automated Bleed Procedure .