Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1780 (Shift Interlock System) >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Shift Lock Actuator
    GM1199544Courtesy of GENERAL MOTORS CORP.
  1. In DRIVE position, depress the shift lock actuator button and realign into the shiftier lever.
  2. Push lever to NEUTRAL.
    3. NOTE: Refer to Fastener Notice .
  3. Install the top screw through the lever slot.

    Tighten:  Tighten the actuator screw to 1.65 N.m (15 lb in).

  4. Shift lever to LOW.
  5. Install the screw at the rear of the shiftier assembly.

    Tighten:  Tighten the actuator screw to 1.65 N.m (15 lb in).

    6. Fig 2: Disconnecting/Reconnecting Shift Lock Actuator Electrical Connector
    GM1341666Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector (3).
    7. Fig 3: Removing/Installing Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  7. Verify the shift lock actuator functions properly.
  8. Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
scientia non olet · About Mike's Workshop Manuals