Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1745 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (5.3L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator & Bolts (5.3L)
    GM899619Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the generator.
  2. Install the generator bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Generator Cable Boot, Head, Nut & Bolt
    GM899614Courtesy of GENERAL MOTORS CORP.
  3. Install the generator cable (3) to the generator, perform the following:
    1. Install the generator cable (3).
    2. Install the generator cable nut (2) to the terminal stud.

      Tighten:  Tighten the nut to 9 N.m (80 lb in).

    3. Slide the boot (1) over the terminal stud.
    4. Fig 3: View Of Generator Electrical Connector
    GM898329Courtesy of GENERAL MOTORS CORP.
  4. Connect the generator electrical connector.
  5. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 5.3L.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About Mike's Workshop Manuals