Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Fuel Pressure Relief Procedure >> Tools Required

Tools Required

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

J 34730-1A  Fuel Pressure Gage

    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Install J 34730-1A  . Refer to Fuel Pressure Gage Installation and Removal .
  3. Loosen the fuel fill cap in order to relieve the fuel tank vapor pressure.
  4. Open the valve on J 34730-1A  in order to bleed the system pressure. The fuel connections are now safe for servicing.
  5. Drain any fuel remaining in the gage into an approved container.
  6. Once the system pressure is completely relieved, remove J 34730-1A  .
scientia non olet · About Mike's Workshop Manuals