Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
    2. Fig 1: View Of MAF/IAT Sensor Electrical Connector
    GM1204792Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the mass air flow (MAF) /intake air temperature (IAT) sensor electrical connector (1).
  3. Remove the radiator support diagonal brace. Refer to Brace Replacement - Radiator Support Diagonal in Body Front End.
    4. Fig 2: Exploded View Of Air Cleaner Assembly
    GM1217755Courtesy of GENERAL MOTORS CORP.
  4. Loosen the 4 air cleaner cover retaining screws (1).
  5. Remove the air cleaner housing cover (2). Lift and rotate the cover in order to remove the cover from the vehicle.
  6. Remove the air filter element (6) and the MAF/IAT sensor (3) from the lower air cleaner housing/washer solvent tank assembly (4).
  7. Separate the air filter element (6) from the MAF/IAT sensor (3).
  8. Inspect the entire assembly for dust, debris, or water. Clean or replace as necessary.
scientia non olet · About Mike's Workshop Manuals