Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1742 (Engine Control System - 4.2L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the camshaft position (CMP) sensor.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

  2. Install the CMP sensor electrical connector (1).
scientia non olet · About Mike's Workshop Manuals