Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Entertainment Systems) >> Repair Instructions >> Video Player Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ensuring Bracket Locating Tabs Are Fully Seated To Roof Bow
    GM792150Courtesy of GENERAL MOTORS CORP.
  1. Carefully install the bracket to the vehicle through the headliner opening, ensuring the locating tabs (1) are fully seated to the roof bow.
    2. Fig 2: Front Bracket Retaining Bolts
    GM778730Courtesy of GENERAL MOTORS CORP.
  2. Partially install the front bracket retaining bolts.
    3. Fig 3: Exposing Rear Bracket Retaining Bolt
    GM792151Courtesy of GENERAL MOTORS CORP.
  3. Carefully pull down on the rearward edge of the headliner in order to expose the rear bolt installation area.
  4. Partially install the rear bracket retaining bolt.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Fully seat the retaining bolts.

    Tighten:  Tighten the bolts to 10 N.m (88 lb in).

    6. Fig 4: Rear Overhead Console Carrier Screws
    GM792148Courtesy of GENERAL MOTORS CORP.
  6. Install the two rear overhead console carrier screws (1).

    Tighten:  Tighten the screws to 1.2 N.m (10 lb in).

  7. Install the video display assembly. Refer to Video Display Replacement .
  8. Verify the video display for proper operation.
  9. Close the video display screen.
  10. Install the bolt cover bezel.
scientia non olet · About Mike's Workshop Manuals