Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Entertainment Systems) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the receiver near the insulator panel.
    2. Fig 1: Antenna Electrical Connector & Receiver
    GM1237408Courtesy of GENERAL MOTORS CORP.
  2. Install the antenna electrical connector (1) to the receiver.
    3. Fig 2: Electrical Connector & Receiver
    GM1237407Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the receiver.
    4. Fig 3: Receiver & Insulator Panel
    GM1236121Courtesy of GENERAL MOTORS CORP.
  4. Install the receiver to the insulator panel.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the nuts retaining the receiver to the insulator panel.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  6. Install the right closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About Mike's Workshop Manuals