Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tail Lamp Assembly Removed

Courtesy of GENERAL MOTORS CORP.

Install the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .
Connect the tail lamp electrical connector.
Push the tail lamp assembly directly forward in order to seat the 2 locking pins.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 tail lamp assembly retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).