Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1736 (Lighting Systems) >> Repair Instructions >> Tail Lamp Circuit Board Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Tail Lamp Circuit Board
    GM732917Courtesy of GENERAL MOTORS CORP.
  1. Install the bulbs to the tail lamp circuit board.
  2. Position the tail lamp circuit board to the tail lamp.
  3. Hold the top 2 locking tabs apart while pushing the tail lamp circuit board into place.
  4. Hold the bottom 4 locking tabs apart while pushing the tail lamp circuit board into place.
  5. Verify that the circuit board is fully seated with the locking tabs fully seated.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the 2 tail lamp circuit board retaining screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  7. Install the tail lamp. Refer to Tail Lamp Replacement .
scientia non olet · About Mike's Workshop Manuals