Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lumbar Mechanism Cable End

Courtesy of GENERAL MOTORS CORP.

Hook the cable end into the lumbar mechanism.

Fig 2: Lumbar Mechanism View

Courtesy of GENERAL MOTORS CORP.

Install the cable to the lumbar spring.

Fig 3: Lumbar Cable And Cable Clip

Courtesy of GENERAL MOTORS CORP.

Install the lumbar cable (2) in the cable clip (1) located on the lower seat back.

Fig 4: Seat Adjuster Cable Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install 2 screws (1) securing the cable to the seat adjuster.
Tighten: Tighten the lumbar cable screws to 6 N.m (53 lb in).
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .