Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1725 (Adjustable Pedal System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Knee Bolster Trim Panel
    GM712827Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal position sensor to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pedal position sensor bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  3. Connect the brake pedal position sensor electrical connector.
  4. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages, and Console.
scientia non olet · About Mike's Workshop Manuals