Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Heat Shield
    GM753689Courtesy of GENERAL MOTORS CORP.
  1. Place the catalytic converter heat shield onto the floor panel studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the heat shield with the 5 bolts.

    Tighten:  Tighten the catalytic converter heat shield bolts to 7 N.m (62 lb in).

  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals