Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of EBCM/BPMV
    GM778051Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the electronic brake control module (EBCM) from the vehicle. Refer to Brake Pressure Modulator Valve (BPMV) Replacement .
    3. IMPORTANT: In the following service procedures, insert rubber plugs or caps on the exposed brake pipe fittings to prevent brake fluid loss and contamination.
  3. Remove the left front brake pipe.
    4. Fig 2: Locating Right Front Brake Pipe
    GM778058Courtesy of GENERAL MOTORS CORP.
  4. Remove the right front brake pipe.
    5. Fig 3: Locating Rear Brake Pipe
    GM778046Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear brake pipe.
    6. Fig 4: Master Cylinder Brake Pipes
    GM778043Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pipe to the brake master cylinder.
scientia non olet · About Mike's Workshop Manuals