Removal Procedure
- Close the window to the full up position.
- Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Remove the rear half of the water deflector. Refer to Water Deflector Replacement - Front Door .
Courtesy of GENERAL MOTORS CORP.
- Disconnect the lock rod retaining clip from the outside door handle.
- Remove the lock rod from the outside door handle.
- Disconnect the lock cylinder rod from the cylinder, if equipped.
- Remove the inside door handle. Refer to Door Handle Replacement - Inside .
Courtesy of GENERAL MOTORS CORP.
- Remove the 3 screws that retain the latch to the door.
- Position the latch in order to disconnect the electrical connectors as needed.
- Remove the latch from the door.
Courtesy of GENERAL MOTORS CORP.
- Noting the position of the inside handle lock rods, remove the inside handle lock rods from the latch.
- Noting the position of the outside handle lock rods, remove the outside handle lock rods from the latch.
- Remove the actuator from latch. Refer to Lock Actuator Replacement - Front Door .