Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Liftgate Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Liftgate Control Module
    GM749979Courtesy of GENERAL MOTORS CORP.
  1. Install the module to the liftgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that retain the module to the liftgate.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the electrical connectors (3) as necessary.
  4. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate (TrailBlazer, Envoy, Bravada)  or Trim Panel Replacement - Liftgate (TrailBlazer EXT, Envoy XL) .
  5. Install the liftgate window garnish molding. Refer to Garnish Molding Replacement - Rear Window in Interior Trim.
  6. Reprogram the liftgate control module. Refer to Liftgate Control Module Programming .
scientia non olet · About Mike's Workshop Manuals