Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 2001 >> Intrigue GL >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Anti-Lock Brake System - Traction Control System - BOSCH 5.3) >> Removal & Installation >> Electronic Brake Traction Control Module (EBTCM) >> Removal

Electronic Brake Traction Control Module (EBTCM): Removal

WARNING: This page is about a different car, the 2000 Pontiac Grand Prix, 2000 Pontiac Firebird, 2000 Oldsmobile Intrigue, and 2000 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. EBTCM is mounted on top of left front frame rail (Camaro and Firebird) or on left side strut tower in engine compartment (Grand Prix and Intrigue). Disconnect negative battery cable. Turn ignition switch to OFF position. Pull out lock tab from EBTCM harness connector and disconnect connector. Disconnect pump motor connector from bottom of EBTCM.
  2. Remove and discard 6 EBTCM-to-Brake Pressure Modulator Valve (BPMV) screws. Using care so as not to damage seal and solenoid valves, pull EBTCM and separate from BPMV. Note location and position of wave spring(s) between EBTCM and BPMV. Remove and discard wave spring(s).
scientia non olet · About Mike's Workshop Manuals