Limit Switch Module: Notes
CAUTION:
Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
NOTE:
Limit switch module may also be referred to as Position Encoder System (PES) module or Position Encoding System (PES) module. Limit switch module comes from manufacturer in preset closed position. Locking pin in top center of module must be left in place until installation is complete.