Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 1998 >> Regency >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Cruise Control System) >> Testing >> Cruise Control Will Not Resume/Accelerate Or Tap-Up/Tap-Down

Cruise Control Will Not Resume/Accelerate Or Tap-Up/Tap-Down

WARNING: This page is about a different car, the 1997 Oldsmobile Aurora and 1997 Buick Riviera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect cruise control module. Turn ignition switch to RUN position. Turn main switch to ON position. Connect a test light between cruise control module connector terminal "C" (Gray/Black wire) and ground. Press and hold R/A switch. If test light glows, go to next step. If test light does not glow, go to step 3).
  2. If test light glows, check for a poor connection or short to ground in Gray/Black wire between cruise control module and multifunction lever. If connection and wire is okay, replace cruise control module. See CRUISE CONTROL MODULE under REMOVAL & INSTALLATION  .
  3. If test light does not glow, check for a poor connection or open in Gray/Black wire between cruise control module and multifunction lever. If connection and wire is okay, replace multifunction lever. See STEERING COLUMN SWITCHES article.
scientia non olet · About Mike's Workshop Manuals