Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 1998 >> Intrigue Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Engine Control System - Tests W/Codes - DTC P0100-P0134) >> DTC P0134 >> DTC P0134: O2S Circuit-Insufficient Activity-Sensor 1 (1.9L SATURN) >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page does not describe the selected car, but rather 65 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start and operate engine for more than 5 minutes. Connect scan tool. Ensure engine coolant temperature is greater than 140°F (60°C). O2S voltage should be varying from less than 391 mV to greater than 491 mV. If voltage is varying as specified, problem is intermittent. See DIAGNOSTIC AIDS . If voltage is not varying as specified, go to next step.
  2. Turn ignition on, with engine off. Disconnect O2S harness connector. Jumper O2S harness connector terminal to ground. If scan tool reads less than 100 mV, check for terminal tightness or faulty O2S. If scan tool does not read less than 100 mV, go to next step.
  3. Remove jumper wire. Using a DVOM, measure voltage at O2S harness connector terminal. If voltage reading is.3-.6 volt (300-600 millivolt), replace PCM. If voltage reading is greater than.6 volt (600 millivolt), check for open ground circuit, terminal tightness or faulty PCM. If voltage reading is less than.3 volt (300 millivolt), check for open signal circuit, terminal tightness or faulty PCM.
scientia non olet · About Mike's Workshop Manuals