Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 1993 >> Cutlass Cruiser SL, 4T60/ME9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> ECM/Pcm Code Charts >> Code 26 - Quad-Driver Error (With 3T40 Trans.) (2 Of 3) >> Notes

Code 26 - Quad-Driver Error (With 3T40 Trans.) (2 Of 3): Notes

On models with 3T40 transmission, QDM "A" fault status on scan tester should read HIGH until 2nd gear switch is closed or brake is applied. To simulate driving in 2nd gear and change status to LOW, disconnect TCC connector, and connect test light between harness terminals "A" and "D".

NOTE: Test number refers to number on diagnostic chart.

  1. 3)

    This step determines which circuit is out of specification.
scientia non olet · About Mike's Workshop Manuals