Code A052 - Left Front Channel In Release Too Long: Notes
This test is designed to detect a motor that is energized too long. This will occur if wheel speed sensor is defective, motor does not turn, left front solenoid is open or motor wires are crossed.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- This step determines if a problem exists in wheel speed sensor that may cause system to be in release too long.
- This step identifies a motor fault or channel circuit being wired incorrectly.
- This step checks for open solenoid.
- This step determines if hydraulic failure is due to solenoid or hydraulic modulator.
- This step releases motor pack tension prior to removal.