Code 13, Open Oxygen Sensor Circuit: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1990 Pontiac Grand Am, 1990 Pontiac 6000, 1990 Oldsmobile Cutlass Cruiser, 1990 Oldsmobile Cutlass Ciera, and 1990 Oldsmobile Cutlass Calais. However, it is still accessible from the selected car via links, so may be relevant.
The O2 sensor is like an open circuit and produces no voltage when its temperature is less than about 600°F (316°C). An open sensor circuit or cold sensor causes "open loop" operation.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Code 13 will set at normal operating temperature if at least 2 minutes have passed since engine start, O2 signal voltage is steady between .35-.55 volt and throttle position sensor signal is greater than 7 percent (1200 RPM). All conditions must be met for a precalibrated period of time.
- This test determines if the O2 sensor, ECM or wiring is at fault.
- Use only a high-impedance DVOM for this test. This checks for continuity in signal and ground circuits. If ground circuit is open, voltage on signal circuit will be greater than .6 volt.