Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Oldsmobile >> 1990 >> Custom Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel Evaporation Control >> EVAP Purge Valve Solenoid

EVAP Purge Valve Solenoid

  1. Disconnect purge valve solenoid harness connector and vacuum hose. Apply 10 in. Hg to ported vacuum side of solenoid valve. If vacuum holds, go to next step. If vacuum does not hold, replace canister purge solenoid.
  2. Using a 12-volt power source, energize purge valve solenoid. Vacuum should release. If not, replace purge valve solenoid. Solenoid resistance should be at least 20 ohms.
scientia non olet · About Mike's Workshop Manuals