Code 24, Vehicle Speed Sensor (VSS) Circuit: Notes
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Code 24 will set (with vehicle speed less than 2 mph) only if the following conditions are met:
- Engine RPM is between 1600 and 3600.
- TPS is greater than 7 percent.
- Gear selector not in Park or Neutral.
- All conditions met for 20 seconds.
- No Codes 21 or 22.
Above conditions are met during road load deceleration. Ignore Code 24 that sets when drive wheels are turning faster than 3 MPH. PM generator only produces a signal if drive wheels are turning greater than 3 mph.
- Ensure that correct PROM is used before replacing ECM.