Additional Service When Replacing Abs Actuator And Electric Unit (Control Unit): Description

When replacing the ABS actuator and electric unit (control unit), the procedures of BEFORE REPLACEMENT and AFTER REPLACEMENT must be performed.

BEFORE REPLACEMENT 

When replacing the ABS actuator and electric unit (control unit), save "Operation log".

AFTER REPLACEMENT 

After replacing the ABS actuator and electric unit (control unit), the following must be performed:

• ABS actuator and electric unit (control unit) configuration. Refer to Work Procedure .
• Air bleeding of brake fluid
• Adjust the neutral position of steering angle sensor. Refer to Work Procedure .
• Perform calibration of the decel G sensor. Refer to Work Procedure .
• Drive vehicle for 1.86 miles (3 km) or more.

NOTE: Save the odometer information of combination meter in ABS actuator and electric unit (control unit).