Special Repair Requirement

PERFORM ECM RE-COMMUNICATING FUNCTION
1. CONSULT
  1. Install ECM.
  2. Using a registered key 2, place ignition switch ON. 2: To perform this step, use the key that has been used before performing ECM replacement.
  3. Maintain ignition switch in "ON" position for at least 5 seconds.
  4. Ignition switch OFF.
  5. Start engine.
Can engine be started?

YES>>

Procedure is completed.

NO>>

Initialize control unit. Refer to CONSULT Immobilizer mode and follow the on-screen instructions.