Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2023 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Drive Mode System (Circuit Diagnosis) >> Circuit Diagnosis >> Drive Mode Select Switch Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK DRIVE MODE SELECT SWITCH SIGNAL CIRCUIT 
    1. Ignition switch OFF.
    2. Disconnect drive mode select switch harness connector and chassis control module harness connector.
    3. Check the continuity between drive mode select switch harness connector and chassis control module harness connector.
      2WD models

      Drive mode select switch BCM Continuity
      Connector Terminal Connector Terminal
      M187 2 M19 80 Existed
      6 57
      AWD models

      Drive mode select switch BCM Continuity
      Connector Terminal Connector Terminal
      M186 3 M18 25 Existed
    4. Also check harness for short to ground and to power.

    Is the inspection result normal?

    YES>>

    GO TO 2.

    NO>>

    Repair / replace harness or connector.

  2. CHECK DRIVE MODE SELECT SWITCH GROUND CIRCUIT 

    Check the continuity between drive mode select switch harness connector and ground.

    2WD models

    Drive mode select switch - Continuity
    Connector Terminal
    M187 1 Ground Existed
    AWD models

    Drive mode select switch - Continuity
    Connector Terminal
    M186 4 Ground Existed

    Is the inspection result normal?

    YES>>

    GO TO 3.

    NO>>

    Repair / replace harness or connector.

  3. CHECK DRIVE MODE SELECT SWITCH 

    Check drive mode select switch. Refer to Component Inspection .

    Is the inspection result normal?

    YES>>

    INSPECTION END

    NO>>

    Replace drive mode select switch. Refer to Removal and Installation .

scientia non olet · About Mike's Workshop Manuals