Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2021 >> Titan SL, RWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Airbag Control System >> Basic Inspection >> Inspection And Adjustment >> Zero Point Reset >> Special Repair Requirement

Special Repair Requirement

  1. PERFORM ZERO POINT RESET 

    SYMBOL CONSULT

    1. Perform "Zero point reset".
      NOTE: When performing "Zero point reset", be careful of the items described as per the following:
      • Perform "Zero point reset" after installing passenger seat to the vehicle.
      • Do not put any objects on passenger seat.
      • Do not apply excessive vibration to the vehicle.
      • Do not touch the vehicle during zero point reset.
      • Do not tilt vehicle.
    2. Select "Start" on "Zero point reset function" screen from "Work support" mode of "OCCUPANT DETECTION".
    3. "Zero point reset function" starts.

    GO TO 2.

  2. CONFIRMATION OF SETTING 

    SYMBOL CONSULT

    1. Proceed to "Zero point reset function" screen from "Work support" mode of "OCCUPANT DETECTION".
    2. Check that "Complete" or "Incomplete" is displayed on "Zero point reset status".
    CAUTION:
    • "Complete" is displayed on "Zero point reset current status" if the seat is reinstalled by seat removal and installation, or "Zero point reset" is already performed.
    • "Zero point reset current status" displays "Incomplete" if a new seat is installed. When turning ignition ON without performing "Zero point reset", front passenger air bag OFF indicator turns ON. When "Zero point reset" is performed, front passenger air bag OFF indicator turns OFF.

    Is zero point reset status "complete"?

    YES

    Print out "Zero point reset current status" screen. Inspection end.

    NO

    Recheck the preliminary check items and perform zero point reset again.

scientia non olet · About Mike's Workshop Manuals