Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
Which DTC is detected?
GO TO 2.
- DTC CONFIRMATION PROCEDURE-1
- Turn ignition switch ON and wait at least 5 seconds.
- Check DTC.
Is DTC detected?
YES
Refer to DTC Diagnosis Procedure .
NO
GO TO 3.
- DTC CONFIRMATION PROCEDURE-2
- Turn ignition switch OFF and wait at least 10 seconds.
- Start the engine and let it idle at least 5 seconds.
- Check DTC.
Is DTC detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END