Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2021 >> Qashqai SL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (3 Of 4) >> Engine (ECM) >> DTC P1715: Input Speed Sensor >> Confirmation Procedure

Confirmation Procedure

  1. CHECK DTC PRIORITY 

    If DTC P1574 is displayed with DTC UXXXX, P0340, P0605 or P0607, first perform the confirmation procedure for DTC UXXXX, P0340, P0605 or P0607.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable.

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine.
    2. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
    3. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END