Data Monitor
|
Monitored item (Unit) |
Description |
|
CAMERA HIGH TEMP (NORMAL/HIGH) |
Displays status of lane camera unit high temperature judgment. |
|
WIPER (Off/Lo/Hi) |
Displays the wiper operating status. |
|
TURN SIGNAL (Off/LH/ RH/LH&RH) |
Displays status of "Turn signal" received from BCM via CAN communication. |
|
VEHICLE SPEED (mph) |
Displays vehicle speed received from ABS actuator and electric unit (control unit) via CAN communication. |
|
Cancel mode 1 (Not occur/Occur) |
Displays the cancel mode in the lane camera for blockage of camera view fully Date monitor 1 |
|
Cancel mode 2 (Not occur/Occur) |
Displays the cancel mode in the lane camera for smeared spot on camera image Date monitor 2 |
|
Cancel mode 3 (Not occur/Occur) |
Displays the cancel mode in the lane camera for blockage of camera view partially Date monitor 3 |
|
Cancel mode 4 (Not occur/Occur) |
Displays the cancel mode in the lane camera for direct sunlight to camera lens Date monitor 4 |
|
Cancel mode 5 (Not occur/Occur) |
Displays the cancel mode in the lane camera for road spray to camera view Date monitor 5 |
|
Cancel mode 6 (Not occur/Occur) |
Displays the cancel mode in the lane camera for blur image Date monitor 6 |
|
Cancel mode 7 (Not occur/Occur) |
Displays the cancel mode in the lane camera for the dense fog Date monitor 7 |
|
Cancel mode 8 (Not occur/Occur) |
Displays the cancel mode in the lane camera for smeared image Date monitor 8 |
|
Cancel mode 9 (Not occur/Occur) |
NOTE:
The item is indicated, but not monitored.
|
|
Cancel mode 10 (Not occur/Occur) |
Displays the cancel mode in the lane camera for sun ray on camera image Date monitor 10 |
|
Cancel mode 11 (Not occur/Occur) |
Displays the cancel mode in the lane camera for frozen windshield Date monitor 11 |
|
Cancel mode 12 (Not occur/Occur) |
Displays the cancel mode in the lane camera for camera alignment Date monitor 12 |
|
Cancel mode 13 (Not occur/Occur) |
Displays the cancel mode in the lane camera for camera out of focus Date monitor 13 |
|
Cancel mode 14 (Not occur/Occur) |
NOTE:
The item is indicated, but not monitored.
|
|
Cancel mode 15 (Not occur/Occur) |
NOTE:
The item is indicated, but not monitored.
|
|
Cancel mode 16 (Not occur/Occur) |
NOTE:
The item is indicated, but not monitored.
|
|
DRIVER ASSIST SYSTEM SET (NO REQ) |
NOTE:
The item is indicated, but not monitored.
|
|
BRAKE OPERATION STATUS (Off/On/CNFRM/UNKWN) |
Displays the brake operating status. |
|
AIMING DONE (not finished/finished) |
Displays status that camera aiming is done. |
|
AIMING RESULT (NOK/OK) |
Displays result of camera aiming. |
|
STEERING ANGLE (deg) |
Displays the steering angle sent from the chassis control module. |
|
YAW RATE (deg/s) |
Displays the yaw rate. |
|
FCTRY AIM YAW (deg) |
Displays the yaw angle result of camera aiming. |
|
FCTRY AIM ROL (deg) |
Displays the roll angle result of camera aiming. |
|
FCTRY AIM PIT (deg) |
Displays the pitch angle result of camera aiming. |
|
LDW SETTING DISPLAY (NTHNG) |
NOTE:
The item is indicated, but not monitored.
|
|
DRIVER ASSIST SYSTEM BZZR (NO REQ) |
NOTE:
The item is indicated, but not monitored.
|
|
LDW LEFT (Off/On) |
Displays the deviating status on the LH side lane. |
|
LDW RIGHT (Off/On) |
Displays the deviating status on the RH side lane. |
|
LDW STATUS DISPLAY (Off/ON/TMP MF/ MF) |
NOTE:
The item is indicated, but not monitored.
|
|
HBA status (not used/AHL failure/AHLNO/failure/unailable) |
NOTE:
The item is indicated, but not monitored.
|
|
HBA REQUEST (NO REQ/LOW/HIGH/UNKWN) |
Displays the status of High Beam Assist request status. |
|
DISTANCE (m) |
Displays the distance between the vehicle and an object detected by the lane camera unit. |
|
RELATIVE SPEED (m/s) |
Displays the relative velocity to an object detected by the lane camera unit. |
|
Initialization ECU (INCOMP/COMPLT) |
Displays the initialization status of lane camera unit. |
|
LOW BEAM STATUS (Off) |
NOTE:
The item is indicated, but not monitored.
|
|
HIGH BEAM STATUS (Off) |
NOTE:
The item is indicated, but not monitored.
|