Symptom Table
- Perform "Data Monitor" of CONSULT to check for any malfunctioning item.
- Check the malfunction combinations.
Malfunction item: x
Data monitor item
Combination switch circuit
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
INPUT 6
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
OUTPUT 5
FR WIPER HI
x
x
FR WIPER LOW
x
x
FR WASHER SW
x
x
FR WIPER INT
x
x
INT VOLUME
x
x
x
x
TURN SIGNAL R
x
x
TURN SIGNAL L
x
x
TAIL LAMP SW
x
x
HI BEAM SW
x
x
HEADLAMP SW
x
x
LIGHT OFF SW
x
x
PASSING SW
x
x
AUTO LIGHT SW
x
x
FR FOG SW
x
x
WIPER OFF
x
x
FR WIPER MIST
x
x
- Identify the malfunctioning part from the agreed combination and repair or replace the part.
Malfunctioning part
Repair or replace
Combination switch INPUT circuit
Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
Combination switch OUTPUT circuit
Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
All Items
Replace BCM. Refer to BCM : Removal & Installation .
If only one item is detected or the item is not applicable to the combinations
Replace combination switch. Refer to COMBINATION SWITCH : Removal & Installation .
All Items are normal
Check intermittent incident. Refer to Inspection .