Diagnostic Test

WARNING: This page is about a different car, the 2017 Nissan 370Z and 2016 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.

START

Do you have CONSULT?

Do you have CONSULT?

YES

GO TO STEP 2 .

NO

GO TO STEP 3 .

PERFORM M/T NEUTRAL POSITION LEARNING

With CONSULT
1. Check that there is no sticking when shifting shift lever to the neutral position.
2. Turn ignition switch ON.
3. Select "M/T NEUTRAL POS LEARN" in "WORK SUPPORT" mode with CONSULT.
4. Touch "Start" and wait a few seconds.
  NOTE:
  Never touch shift lever. Otherwise learning may not complete normally.
5. Make sure the "COMPLETE" is displayed on CONSULT screen.
  NOTE:
  If "INCMP" is displayed, return to step 1 and repeat the procedures again.
END

PERFORM M/T NEUTRAL POSITION LEARNING

Without CONSULT

NOTE:

It is better to count the time accurately with a clock.
It is impossible to switch the learning mode when a clutch interlock switch circuit has a malfunction.

Check that there is no sticking when shifting shift lever to the neutral position.
Turn ignition switch ON and wait 5 seconds.
Within 5 seconds repeat the following operation 3 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
Wait 3 seconds while S-MODE switch is released.
Wait 5 seconds while pressing S-MODE switch.
Wait 3 seconds while S-MODE switch is released.

Within 5 seconds repeat the following operation 5 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.

ECM starts M/T Neutral Position Learning.

NOTE:

Never touch shift lever. Otherwise learning may not complete normally.

Courtesy of NISSAN NORTH AMERICA, INC.

Shift position indicator on combination meter blinks for 5 seconds when the leaning is complete.
NOTE:
If shift position indicator does not blink or blinks continuously, return to step 1 and repeat the procedures again.

END