Component Function Check

With CONSULT

1. Turn ignition switch ON.
2. Select "ENGINE" using CONSULT.
3. Select "CLUTCH P/P SW" in "DATA MONITOR" mode.
4. Check "CLUTCH P/P SW" indication under the following conditions.

   Monitor item	Condition		Indication
   CLUTCH P/P SW	Clutch pedal	Fully released	OFF
   		Fully depressed	ON

Without CONSULT

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   E16	92 (Clutch pedal position switch signal)	E16	108	Clutch pedal	Fully released	Approx. 0V
   					Fully depressed	Battery voltage

Is the inspection result normal?

YES

INSPECTION END

NO

Go to Diagnosis Procedure .